JG Speedfit tank connectors are push-fit fittings for connecting plastic or copper pipes to cold water tanks. The tank connector is designed for tanks with a minimum wall thickness of 4mm.

Push the JG Speedfit tank connector push-fit fitting onto the pipe and tighten the connector by hand. Push the collet towards the body of the push-fit fitting and pull the pipe to release the connection. By eliminating the need for hot works or tools in the loft environment, push-fit fittings are faster and easier to install in confined spaces than traditional methods. Designed, manufactured and assembled in the UK.

Speedfit Features

- Push-fit and demountable connections

- Suitable for hot and cold water and central heating systems

- Grip and Seal connection

- Lead free and non toxic

- No scale build up and Corrossion Free

- BSI and WRAS approved

- Pipes Speedfit fittings can be used with Copper pipe to BS EN 1057 and Speedfit Barrier Pipe to BS7291.

- Speedfit fittings CANNOT be used on stainless steel pipe.

- Standards Speedfit products are designed and manufactured under a fully integrated system assessed by B.S.I. to BS EN ISO9001. They are approved by the Water Regulations Advisory Scheme and BBA. Speedfit PEM, PSE and SFM Fittings and Speedfit Barrier Pipe are kitemarked to BS7291 Parts 1, 2 and 3, Class S (Licence No. KM39767).

Applications

- Mains fed and indirect cold water systems

- Vented and unvented hot water systems

- Vented and sealed central heating systems

- DO NOT USE FOR Gas, fuel oil or compressed air applications.

Connection to compression fitting

Many, but not all, compression fittings are suitable for use with plastic fittings and pipe. Users should therefore check for compatibility. Compression fittings with short tube stop depth or hard olives should not be used with plastic fittings or pipe. When using compression fittings with Speedfit pipe, a Standard Pipe Insert (prefix TSM) must be used to withstand the compressive pressure of the olive. The olive must be located within the length of the pipe insert and the pipe fully inserted into the fitting. The connection should not need more than 2 full turns after the olive has gripped the pipe. Copper olives are preferable to brass olives.